In the links below, see the videos of Titan experts\' suggestions for effective insulation of bathrooms, roofs, and garden roofs using Stop Lake waterproofing.\r\nhttps://nanotitanco.com/page/roofgardenvid\r\nhttps://nanotitanco.com/page/wcvid\r\n1- Roof sealing: \r\nInsulation of the roof is one of the most common sealings done in the building. Although there is often no negative pressure water on the roof, due to the direct contact of this part with the atmosphere, it is very important to pay attention to the type of climate of each region and have a correct understanding of its changes in choosing the type and how to implement insulation and its durability.\r\n****How to insulate the roof?****\r\nRoof insulation is one of the most common types of sealing in the construction industry, which is commonly done with bitumen-based insulation. Qirguni and Izogam are the most common insulations that are used to seal the roof surface. As with the advancement of technology, Izogam replaced Qirguni; Today, with the advancement of technology, new insulations, mainly polymer, are being replaced by Isogam by eliminating the defects of Isogam. Choosing the right insulation for the roof is one of the most important stages of roof insulation.\r\nWhat points should we pay attention to in order to buy a suitable insulation for sealing the building?\r\n * Climate:\r\nOne of the most important factors in choosing insulation for sealing the roof is paying attention to the climate in which the building is located.\r\nHot air causes many insulations to melt, and this shows itself in the following ways:\r\n * If insulation (mainly bitumen) drips from under the roof\r\n * Insulation flowing into the shoes and blocking them\r\n * Impossibility of traffic on the roof during hot hours due to the softening of the insulation\r\nCold weather causes drying and cracking of many insulations. Insulation cracking means loss of sealing.\r\nIn the past, operators used to solve these two problems in Qirguni by mixing different ratios of hard and loose bitumen according to the air temperature, which was a professional job. But more important than the average air temperature is the difference between night and day temperature and the temperature difference of different seasons in that region. In desert areas where the temperature difference between night and day and in mountainous areas where the temperature difference in the cold and hot seasons of the year is very large; The work faces a challenge because the problem cannot be solved even by estimating the percentage of mixing professionally.\r\n * The amount of adhesion of the insulation to the surface:\r\nThis feature of the waterproofing material should be checked from two points of view:\r\n1. The amount of adhesion of the insulation to the dominant material of the surface\r\n2. The degree of adhesion of insulation to other materials used on the surface\r\nThe waterproofing insulation must be able to securely and firmly adhere to the work surface and not be separated from it. In this case, it is very important to determine the dominant material used on the surface and estimate the amount of adhesion of the insulation to it. A point that should not be overlooked is that sometimes the insulation adheres well to the dominant material used on the surface, but because the surface is not uniform and other materials are used along with it, our insulation may not adhere well to those surfaces. As a result of separation of the insulation from this small part of the work, the entire surface of A
Tehran
