Building a prefabricated tank

Building a prefabricated tank

The cost of building a prefabricated tank is much lower than that of concrete pools due to its easy installation and the short duration of its installation in two stages: sub-construction and installation of a ready-made pool on site. Mixing the floor, preparation of concrete and rebar, high cost of molding and implementation of concrete and slowly tarping and its system, floor construction, tilting, transportation, etc., all of the above, and most importantly, the implementation of the above steps requires a large number of human resources. All of the above are reasons for the high cost of building a concrete tank. In addition to the cost of construction, in terms of timing, the preparation and construction of a concrete tank in the best conditions requires at least 25 days, while the full implementation of the prefabricated tank is a maximum It takes 4 days. In terms of land area, pre-fabricated tanks are applicable in the minimum area of ​​the land, if a larger area of ​​land is needed for concrete resources. It should be noted that increasing the diameter of the pools or increasing the number and arrangement in the design of pre-fabricated tanks can to reduce the amount of land around the pools.

Part of the advantages of prefabricated 3-walled vertical cylindrical tanks compared to concrete tanks.
Possibility of moving and transferring tanks due to the critical water conditions in the country
Possibility of installing tanks in inaccessible areas (mountains) and areas that have less materials such as ready concrete and manpower.

Fast and easy installation and operation of the tanks in the shortest time
The cost of service, maintenance and operation is much lower
- The resistance of the tanks against earthquakes and strong winds \r\ The resistance of tanks against possible settlement and drifts on the ground
Very low cost of inspection and supervision by the employer during the construction and implementation of tanks
Without leakage and water wastage due to having the inner layer of Aquatex and the possibility of implementation on The surface of the ground
All parts of the tank have been hot-plated and pre-painted, and this type of coating has increased the lifespan of the tanks of this company.
The possibility of an unconditional (10) year warranty, which is not available in any other type of tanks.

The possibility of repairing and replacing parts easily and in the shortest time without destruction
High resistance to Refrigerative and thermal stress
Special design capability based on weather conditions and regional zoning
The possibility of inspection and monitoring is much easier to detect defects and failures compared to concrete tanks (unlike concrete tanks that in case of damage To see the rebars, it is necessary to destroy the concrete cover in order to observe and check the defects, no destruction is needed in prefabricated tanks to recognize the possibility of better zoning of the network by dividing resources at the network level. Prefabricated tanks have a high scrap value and It can be replaced by the manufacturing company at the lowest price
The special design of the air vent is in such a way that it completely transfers the moisture to the outside and prevents the change of taste, smell and taste of the water.
The final layer And it is in direct contact with water without any porosity and has a drinking water maintenance grade from the country's AFA Health Office.