Repairs of all kinds of belt tensioners

Repairs of all kinds of belt tensioners

The largest and most equipped specialized repair of all types of belt tensioning machines in West Tehran

Avinplast Maham, due to the capabilities of its experts as well as the supply of factory parts and stocks of all types of belt tensioning machines, has been able to repair all types of belt tensioning machines in terms of provide mechanical and electronic to its customers. So that this company is now considered one of the largest and most equipped specialized belt repair and consulting centers in the west of Tehran.
Repairing and adjusting the belt tensioner device:
The purpose of repairing and adjusting is to fix the defects or possible defects of the device, which is carried out through the following steps:

1. Initial test and troubleshooting:
After acceptance, the device will be checked by the relevant expert and its initial defects will be identified so that if needed, a proforma invoice will be issued for the customer's information.
2. Cleaning the device:
At this stage, all the parts of the device that need to be cleaned are removed from the device and cleaned together with the device. During this stage, the device is completely cleaned and if there are parts with problems that were not seen in the initial troubleshooting, they are identified in this stage.
3. Troubleshooting and parts replacement:
Identified defects are fixed, and defective parts are replaced, then the device is prepared for initial testing.

4. Retesting and fixing possible defects:
The device is tested by the expert himself and if there are any remaining defects, it is fixed. It was not and it is local. The final test is also performed by the customer's representative.



Complete service and renovation of the belt tensioner
If the device has general or multiple defects, it will be repaired and adjustment and cannot be returned to the working cycle at a normal cost, the "full service and renovation" option is used for the device. For example, in some cases, the entire electronic part of the belt tensioner, including rewiring and changing the electronic board, etc., is renewed. Cash at the request of customers
Nowadays, industrial units have taken a step towards cost management, among which one of the factors of interest is the costs caused by the stoppage of production due to the failure of tools and machines. In addition to the lack of production and manpower and repair costs are detrimental to the organization, sometimes it is observed that a defect has occurred or a defective part has caused damage to some other parts of the device as well.
As a result of the services of the course It can be a suitable and effective solution to prevent the mentioned cases.
Please visit our websitehttp://www.avinplast.com.